Replacing The Light Bulbs - Quality Craft MM769D-36FMC Manual De Instrucciones

REPLACING THE LIGHT BULBS

Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 x 40W type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into top left corner hole and
bottom right corner holes as shown in the diagram. Secure the 10 smaller
screws into the remaining holes. Make sure the screws are in the correct holes
and have been tightened.
Step 5: Plug in the unit.
CLEANING
To clean unit first turn off controls on unit and unplug the unit from power source.
To clean glass display panel; remove dust with clean dry cloth or to remove finger prints
and other marks clean glass with clean damp cloth. Do not use abrasive cleaners or
spray liquids on glass display panel surface. Metal and metal painted parts should
be cleaned with damp cloth. Do not use abrasive cleaners or spray liquids on these
surfaces.
WARRANTY
Every electric fireplace heater is tested before it leaves the factory and it is guaranteed
for one year. If the unit should fail to operate correctly within one year from the date of
purchase, call customer service at 1-800-459-4409 (EST). We will, at our discretion
either repair or replace the unit. It will have to be returned to us freight prepaid and
we will return the repaired or replaced unit to you freight prepaid. The company's sole
obligation is to repair or replace the unit. This warranty is void if in the opinion of Quality
Craft the unit has been tampered with, altered, misused, damaged, abused or used with
the wrong power source. Light bulbs are not covered by this warranty. The warranty is for
homeowner use only and does not cover units used in commercial situations.
Imported by
Quality Craft Ltd.
Laval, Quebec, Canada H7S 2G7
1-800-459-4409 (EST)
www.qualitycraft.com
Made in China
3