How To Wear - INOPERA A4 Serie Guia De Inicio Rapido

03 Charging
Close the case lid when charging. When using
for the first time, it is recommended to fully
charge the earphones before use.
1. Connect your power supply to the rear
charging case port with supply a Type-C
cable. The power input is limited to 5V/1A.
2. Place earphones in the charging case to
begin charging. Charge capacity will be
displayed in percentage of complete charge.
The power status RED LED will turn GREEN
when charge is complete.

04 How to wear

04
05 Pairing the A4 Series
When LEFT and RIGHT earphones are taken out from the charging case, they will be
automatically turn on and interconnect. After the connection is successful, the LEFT
earphone enters the pairing mode as the host of the binaural mode (the LEFT earphone
enters the white and green lights alternately, and the RIGHT earphone does not flash).
Tip: This earphone remembers the devices that were
previously paired. If you have previously paired
successfully, and your device's Bluetooth is active, the A4's
will automatically connect when you remove them from
the charging case.
Attention: Please complete the first initial pairing within 5
minutes, otherwise the earphone will automatically shut down.
If shutdown occurs, you will need to put the earphones back
into the charging case and take them out again.
05