Tetra FilterJet 400 Instrucciones página 12

UK
PRODUCT BASICS
Product description
FilterJet 400/600/900 is a circulating pump for aquaria with an adjustable pump
housing and water distributor. The filter sponge prevents dirt particles from en-
tering the pump.
Intended use
Only use the FilterJet 400/600/900
• for water circulation in aquaria,
• with chlorine-free tap water,
• in indoor areas,
• for private use,
• in line with the technical data,
• at water temperatures of +4 °C ... +35 °C.
ASSEMBLY
Procedure:
Fig. B
1. Connect the air hose to the venturi T-piece.
– Remove the stopper from the venturi T-piece.
2. Fix the water distributor to the venturi T-piece.
3. Connect the venturi T-piece to the pump housing.
4. Attach the air hose guide to the pump.
5. Push the air control valve into the air hose until it will go no further. Clip the
air hose into the air hose guide.
6. Connect the pre-filter adapter and pre-filter to the pump housing and slide
the filter sponge over it.
SET-UP
• The side of the aquarium must be clean and free of grease so that the
suction cups can be attached securely.
• Ensure that the pump is mounted so that it is not possible for water to spurt
out of the aquarium.
12
FilterJet 400/600/900