Steam Ironing; Steam Shot - Water Spray; Dry Ironing - TREVIDEA G3 Ferrari G40016 Manual De Instrucciones

•
It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since the ironing plate heats faster than it cools
down.
•
When you do not know the composition, it is recommended to iron a non-visible part of the it,
starting from the lowest temperature to find the most suitable temperature.
•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin
it. When ironing at maximum temperature (MAX), it is recommended to place a cloth between
the ironing plate and the fabric.
Setting the temperature
1) Place the iron vertically.
2) Plug the device to the electrical outlet.
3) Select the temperature regulator (10) according to the symbols shown on the previous page. The
chosen symbol has to be aligned with the mark placed on the tank. The iron plate temperature
control light shows that iron plate (8) is warming up. Wait until light turns off to start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is
constant. If you lower the thermostat, do not start ironing until the iron temperature control light
turns off.

STEAM IRONING

Before using the steam check that the water contained in the tank is enough. Adjust steam power
using the control knob (3). Place the steam control knob between minimum and maximum depending
on the amount of steam required and temperature.
Caution: the iron provides continuous steam only if it is held in a horizontal position and if the plate
is hot. It is possible to stop the continuous jet of steam by placing the iron vertically or placing the
steam control (3) to "0". To avoid the dripping of water, it is recommended to only use steam at high
temperatures.
STEAM JET – WATER SPRAY
Steam jet
: press the steam-shot button (4) for having a vigorous jet of steam which can penetrate the
fibers and soften even the most stubborn creases. Wait a few seconds before pressing.
By pressing the button periodically is also possible to freshen up curtains, hanging clothes, etc ...
Caution: the steam shot function can only be used at high temperatures; stop the jet when the
temperature control light lights up, start again when it goes out.
Water spray
: press the water spray button (5) slowly for having dense spray; press fast for
vaporized spray. Caution: make sure there is water in the tank. For delicate fibers it is advisable to
moisten the article before using the spray. To prevent stains, do not use the spray over silk and
synthetic fibers.

DRY IRONING

To perform dry ironing, move the steam regulator (3) in "0" position. In this position, the steam
emission is disable, otherwise the water spray option is still unable.
Do not iron
10