Troubleshooting - Parker SCPS01 Manual De Instrucciones

6.

Troubleshooting

Error message Description
No connection
to the pressure
switch interface
No response
from pressure
switch
66
The Setup
Interface cannot
be found.
It is possible
that no pressure
switch is con-
nected.
The toggle
switch on the
Setup Inter-
face is not set
properly.
Remedy
Install the required drivers if you
have not already done so (refer to
the "System Installation" Chapter).
Connect the Setup Interface to
an open USB connection on your
PC. When the drivers are properly
installed, a green LED should il-
luminate after a few seconds.
Connect a pressure switch to
the M12 socket on the Setup
Interface.
Set the switch on the Setup
Interface to the proper type (PNP
or NPN) to match the connected
pressure switch.