Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
A -
Computer
Head
C - Transmitter
F -
2 Zip
Ties
Step 1. Mount transmitter (C) on right fork leg (as
viewed when riding the bike) using the shim and 2 Zip
ties (F). The side marked "Bike Sensor" must be on the
inside, facing the wheel. Do not tighten yet.
F
The distance between the sensor and
magnet is better to be smaller than 5mm.
Step 2. Install Spoke Magnet (D) onto a spoke on the
front wheel. Make sure sensor is secure and does not
interfere with spokes.
M A X
Step 3. Align the Transmitter (C) level with the Spoke
Magnet (D) aligning the "Bike Sensor" marking on the
Transmitter to the magnet. Rotate the transmitter so
that it is 5mm or less from the magnet, but not touching.
Tighten the zip ties.
Step 4. Install the Handlebar
Mount (B) by peeling off the
backing on the bottom pad,
placing it on the handlebar
and use 2 zip ties (F) to
attach. Tighten.
Handlebar
B -
Mount
D -
Spoke
Magnet
C
D
mm
5mm or less
B
90°
Install the battery (E) into the
Computer Head (A) using a
coin to turn the cover. Install
the battery with the (+)
facing the battery cover and
replace the cover. Should
the display show irregular
gures, take the battery out
and re-install it.
Step 5. Slide the computer
head onto the mount until it
snaps rmly into place.
PROGRAMMING THE COMPUTER
Step 1: Set the Wheel Value –
First calculate your wheel
circumference by measuring
the diameter of the entire
wheel and multiplying by 3.14.
Example: This wheel measures
686mm in diameter. 686 x 3.14 =
2154.04. Enter the rst 4 digits (2154) "2060" appears
on the screen when the battery is installed, with the last
gure ashing. Press the RIGHT button to advance the
digits as needed, then press the LEFT button to con rm
and advance to the next digit.
Step 2: Set The KM/M selection will appear. Press the
RIGHT button to choose kilometer or mile selection. Press
the LEFT button to con rm and proceed to Clock mode.
Step 3: Set the Clock– The clock function will appear at
the bottom of the screen. Press and hold the LEFT
button for 3 seconds to enter 12/24H mode. Press the
LEFT button to select between 12 and 24-hour format.
Press the RIGHT button to con rm. Next, the hour digits
will start to ash. Use the LEFT button to select the hour
and press the RIGHT button to con rm. Repeat for
9
minutes digits. Press the RIGHT button once more to set
the clock. NOTE: In 12-hour mode, "A" or "P" will
appear on screen to designate AM or PM.
Step 4: Test to Ensure Proper Installation– Now that the
computer is programmed, insert it into the bracket. Spin
the front wheel. The speed should be shown on the
L<70cm
main screen as the computer starts recording data.
(Refer to Troubleshooting Section in case of problems).
COIN
Battery cap
3V
CR2032
A
Release Catch
Off
On
TIRE DIAMETER IN MM
X 3.14= CIRCUMFERENCE
(See example)
E
686mm
Publicidad
Tabla de contenido
