ION TOTAL PA LIVE Guia Del Usuario página 11

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Total PA
Main Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Use the Control knob to raise the
Mic input volume, turn down the source volume, or turn down the music volume from your
source.
The Display shows "NONE": If a USB drive or SD card is already properly inserted, make sure it
contains playable files (MP3 files).
If you cannot connect your audio device to Total PA
•
Have your audio device (e.g., smartphone or tablet) and Total PA
as possible while trying to connect. Make sure both the audio device and Total PA
are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Total PA
other audio device and restart the search process. If this does not work right away, power
™
off Total PA
more information.
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and back on.
You can find this under the Bluetooth menu in the Settings for your phone or other audio
device.
If this does not work, and you have connected to Total PA
in the list of available or previously connected devices in your audio device's Bluetooth
menu, tap the "gear" or "i" icon located next to it and then select Unpair or Forget. Turn
™
Total PA Live off and back on and try pairing again once it reappears in your available
devices list.
Note: If Total PA
range, you may need to repeat this process with that audio device to fully disconnect.
If you experience audio dropouts while playing music from a Bluetooth device, this may be
happening because your unit is trying to link to another speaker. This can occur if you power off
a speaker that was linked to your unit or if you have just turned on your unit and it is in Stereo-
Link mode. To stop the audio dropouts, exit Stereo-Link mode by double-pressing the
Repeat/Link button. Alternatively, you can wait for your unit to link to another speaker if there is
one within range.
If you would like to stop your speaker from automatically linking when you power it on,
make sure you double-press the Repeat/Link button to exit Stereo-Link mode before you
power it off.
Live and then power it back on. See
™
Live has been paired to another audio device recently that is still within
™
Live via Bluetooth:
™
Live to disconnect Total PA
Pairing with a Bluetooth Device
™
Live before, find Total PA
™
Live using the
™
Live as close together
™
™
Live from any
™
Live
for
Live
11