ION TOTAL PA LIVE Guia Del Usuario página 6

11. Clip LED: The Clip LED will flash red if the signal from the input jacks or Media Panel
audio source is clipping (distortion from an overly loud signal). If this happens,
decrease the setting of the Main Volume knob or the volume for the Aux/Mic Input (if
a loud device is plugged into either).
12. Light Mode Button: Press and hold this button to turn the Party Starter
on. Press and release this button to toggle between one of these five modes for the
lights on the front panel.
•
Color Cycle: The lights slowly glow and cycle through colors. This is the default
mode when Total PA
•
Beat Sync: The lights flash and change colors according to the tempo of the music
playing on the speaker. For the best lighting effect, you may need to adjust the
volume of your device, the source volume, and/or the main volume.
•
Color Wheel: The lights rotate in a wheel of all colors.
•
Color Beat Sync: The lights rotate in a wheel of all colors and change direction and
speed according to the tempo of the music playing on the speaker. For the best
lighting effect, you may need to adjust the volume of your device, the source
volume, and/or the main volume.
•
Off: The lights turn off.
13. Power Cable Input (IEC): Insert the included power cable here to charge the unit.
14. Power Switch: Flip this switch to toggle the speaker's power on or off. Your previous
settings will be remembered when powering off and on again.
Note: Total PA
6
™
Live is first powered on.
™
Live will power off after 15 minutes with no audio playing.
™
lights off or