Lagrange GLACES CREATIV Modo De Empleo página 42

LAGRANGE Turbine a? glace:LAGRANGE Grill'Pierre
CAUTION :
Never use the removable bowl in a microwave, oven
or any other heating appliance.
The removable bowl is fragile, take care not to
scratch it while cleaning.
Do not put very hot liquid inside the bowl and never
put it under very hot water when it is very cold.
IMPORTANT: In order to transfer the cold from the fixed bowl
to the removable bowl, put a small spoonful of alcohol in the
fixed bowl and then place the removable bowl. You may
substitute alcohol by a mixture of 1 teaspoonful of fine
diluted salt in 2 teaspoonfuls of water.
Never operate the appliance without the cover in order to
prevent any loss of refrigeration.
Using the timer
————————————————————————————
The electronic timer allows you to programme the
O
preparation time.
Important: When the timer goes off the mixing process
O
stops but the refrigeration process continues. Once the
ice cream is ready, the appliance must be put in the
"off" position to turn off the appliance. (the indicator
lamp goes off)
To set the timer, press the "time setting" button several
O
times until the desired time display
Press the "start time" button to start the timer.
O
11/02/08 17:14 Page 43
When the time stops flashing, this shows that the
O
preparation has begun.
If you wish to modify the time, press the "stop time" button
O
and repeat the above operation.
The end of the preparation time will be indicated by an
O
audible signal 30 seconds before the end of preparation.
CAUTION: The signal indicates that the programmed time
O
has elapsed but does not indicate that the ice cream is
ready. If, however, after the end of the time set the ice
cream is not of proper consistency, press the "start time"
button to restart the process for 5 minutes.
Starting
Before use, prepare your ice cream mixture (see recipes).
If you are using a hot preparation, let it cool in the refrigerator
until the mixture is at the refrigerator's temperature
(about 10°C).
Place the appliance on a flat surface and make sure that the
O
ventilation grilles are not obstructed.
Connect the assembled appliance to the mains
O
Press the cooling On button (located on the motor unit);
O
the indicator light comes on to indicate that the process
has begun.
Wait for 5 minutes then start the blender function by
O
pressing the button located on the blender motor.
41
————————————————————————————————————