Friedrich MW18Y3F Manual De Funcionamiento página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION
Turn on the Power
1
In the case of a direct line connection, turn on the cir-
cuit breaker.
Load Batteries (AAA/R03/LR03 × × × × × 2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
2
Insert batteries.
Be sure to align the battery polarities (
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 6 W).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 6 W) again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
G The Remote Control Unit must be pointed at signal receiver (Fig. 1 4) to operate
correctly.
G Operating Range: About 7 meters.
G When a signal is properly received by the air conditioner, a beeping sound will
be heard.
G If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
Press in
Screws
1 Mount the Holder. 2 Set the Remote Control
Unit.
06B029_9315255037-01_En
) correctly.
/
) buttons (Fig. 6 P) to
Insert
3 To remove the Remote
4
mark.
Slide up
Pull out
Control Unit (when use at
hand).
2006.2.6, 10:52 AM
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
G Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit's operating range becomes ap-
preciably reduced, replace the batteries
and press the RESET button with the tip
of a ballpoint pen or other small object.
En-4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mr18y3f

Tabla de contenido