SUNTEC KLIMATRONIC HEAT WAVE STYLE 1000 Manual De Instrucciones página 11

broken!
 Never open the appliance on your own. Refer to a
qualified expert, if repairs are necessary.
 This product is intended for household use only.
 This heater must not be placed directly under a wall
outlet.
 Do not place the heater right next to bath tubs,
showers or swimming pools.
Warning: In order to avoid overheating, do not
cover the heater
Installation and first use
 Take the appliance out of the packaging and remove the protective
bag.
 If you wish to use the appliance at different locations, mount
the supplied stand leg. Ensure that they are mounted
securely with the provided screws. Then place the appliance
on an even, firm and clean surface, and follow the safety
distance between appliance and other object.
 If you wish to install the appliance at a fixed location, such as
a wall, drill two holes with a difference of 120 mmand insert
the dowels.
Insert the screws, so that they protrude about 6 mm. Hang
up the appliance by using the device on the backside.
 CAUTION: Before you attempt to drill holes, make sure that
concerning part of the wall does not contain any wires or cables. Furthermore, all screws should be
securely fixed in the wall and the appliance should be mounted securely! Observe the following safety
distances!
 Always place the appliance with a sufficient safety distance to inflammable materials or gases.
 For installation in bathrooms, a minimum safety distance of 60 cm in all directions to all pipe
installations, wash basins, bath tubs and showers is required! Please follow the sketches in section
I!
The height of installation on a wall should be between 15 and 30 cm.
 The distance between appliance and ceiling must be at least 50 mm.
 Ensure that housing, heating element, power cord and plug are not damaged.
 Only use outlets with a mains voltage that corresponds to the rated voltage of for appliance. This
appliance requires a voltage of 230V, 50Hz and a current of not more than 15A. Only connect the
appliance to an outlet after checking the voltage.
Operating Klimatronic Heat Wave Style
 It consists of two switches, a thermostat control, and a power setting switch.
 At first the thermostat control should be turned clockwise to full position. The appliance starts then
to warm the room at maximum power.
The red indicator light shows this visually!
 When the desired room temperature is reached, you can turn the
control back to the position where the appliance tum off (you will
hear a "click" and the green indicator lights up).
.