Installation And Assembly; Unpacking & Assembly - Urrea HG909 Manual De Usuario

Bypass Mode: In bypass mode, high pressure
pump recirculates water because spray gun
trigger is not pulled.

INSTALLATION AND ASSEMBLY

Your pressure washer requires some assembly
and is ready for use after it has been properly
serviced with the recommended oil and fuel.
Tool need open-end wrench 10 mm, 14 mm,
17 mm.
UNPACKING
When unpacking check to make sure that all
parts are included. If any parts are missing or
broken, please call our distributor.
Assembly the wheel: Lift the frame with one
hand and attach one of the wheels by pressing
the wheel's pin and inserting the wheel shaft
into the main frame. Align the pin with the
hole on the frame until it snaps in. Repeat it
for the opposite side (Fig. 1).
Fig.1
E N G L I S H •
NOTE: Do not over tighten the nuts, the wheels
must be able to rotate freely.
Insert the upper han-
dles into the main
frame. Align the holes
and insert the bolts
and tighten the nut
firmly using a span-
ner and screwdriver
(Fig. 2).
Attach the trigger gun
storage hook to the
right hand side of the
upper frame using the
bolts and nuts pro-
vided. Attach the high
pressure hose storage
hook to the left hand
side of the up frame.
Tighten the nuts firmly using a spanner and
screwdriver (Fig. 3).
Preparing Pressure Pump: The pressure pump
has a shipping plug inserted into the opening
for the pump breather plug.
WARNING: Failure to remove shipping plug
and replace it with the dipstick/oil plug will
damage pressure pump. Failure to add pump
breather plug could void warranty.
· Using an 17 mm open end wrench or socket
wrench, remove shipping plug from pressure
pump. Discard shipping plug (Fig. 4).
· Remove pump breather plug from parts bag
and insert it into pressure pump (Fig. 5).
Fig.4
Insert Remove
· Tighten pump breather plug securely by
hand. Do not use open end wrench or socket
wrench to tighten. Using a wrench to tighten
pump breather plug could strip threads.
· Use sight glass on end of pressure pump to
ensure pump oil is at 1/2 of the sight glass level.
· Add oil to pressure pump if level is below
indicator on oil gauge. Use 30 weight non-
detergent oil.
U se r's m a n ua l
Fig.2
Fig.3
Fig.5
1/2 Oil level
19