Installation - Hitachi DHWT-200S-3.0H2E Manual De Instrucciones

INSTALLATION

3 INSTALLATION
3.1 PRODUCT GUIDE
Unit type: Domestic Hot Water Tank
Capacity (L) 200-300 Litres
DHWT XXX
3.2 GENERAL NOTES
3.2.1 Components at receipt
Domestic hot water tank
3 PMML0347B rev.1 - 06/2016
S= Stainless
Position-separating hyphen (fixed)
3.0 kW
S - 3.0
Electrical heater
Series
E = Made in Europe
H 2 E
DHWT-(200/300)S-3.0H2E is a stainless steel indirect water
heater. The product is designed for heating domestic hot water
from an external heat source such as heat pump.
Unwrap the product carefully to avoid damage. Install the
product on a flat, even surface designed to carry the full weight
of the product when filled with water. Adjust the factory fitted
adjustable feet as needed. The product must be installed in an
upright, level position. All piping and electrical work must be
performed by an authorized installer.
Before filling unit with water it is recommended to fit the electric
power cable, see "9.5 Electric heater".
On tilted floors the appliance must be installed upright and level
by adjusting the built-in feet. Units must be securely fastened to
the wall.
This appliance is intended to be permanently connected to the
main water supply.
Only safety valve approved to NBI 06870/387 is allowed for use
with this product.