Wayscral NO7066 Manual De Instrucciones página 34

measured pressure value is not 0, simultaneously
EN
press and hold the unit toggle / LED
SET buttons for 3 seconds. The appliance will
enter the automatic reading clearing process,
and the display will flash rapidly.
NOTE: The product has been cleared from the
factory. Due to altitude differences, clearing
readings can increase the measurements
accuracy. Do not connect the inflated items
when clearing.
CHOOSING THE MODE
Short press the SET button to select desired
inflatable mode.
C a r m o d e ( f o r
reference)
M o t o r c y c l e
m o d e ( f o r
reference)
Bicycle mode
Custom mode
Ball mode
CHOOSING THE UNIT
Short press the unit toggle/LED lamp button
to select desired air pressure unit. The unit
conversion formula is as follows:
• 1 PSI = 6.89 KPA
• 1 kg/cm
PRE-SETTING PRESSURE VALUE
To increase or decrease the desired pressure,
use the "+" or "-" buttons.
• Press quickly the pre-set +/- button for small
adjustments.
• Press and hold the pre-set +/- button for
larger adjustments.
IMPORTANT:
• The electric air pump can automatically pre-
set the air pressure value accordingly to the
chosen mode.
• The appliance has a memory function. When
turning on, the mode will be the same as
chosen last time.
STARTING THE AIR INFLATION
1. Refer to the REFERENCE TABLE.
2. Turn on the device.
3. Place connector on input valve stem and
push down.
4. Short press the power button to start the
air inflation. During inflation the display
shows the real-time pressure value.
CAUTION: Operation over an extended period
of time will overheat the unit and damage the
electric air pump. A sluggish operation of the
product or if the exposed metal fittings get
too warm to the touch should indicate to you
that the unit has been operating too long and
is overheating. When this occurs stop the unit
immediately, and let it cool for approximately 30
minutes before resuming operation.
CANCELLING THE AIR INFLATION
Short press the power button to stop inflating.
When the air pressure reaches the pre-
set pressure value, the inflatable treasure
automatically stops inflating.
32
MODE
2
= 98 KPA
Measured pressure
Inflation completed
Pre-set pressure
DEFAULT
35 PSI/2.4bar 0-65 PSI
40 PSI
38 PSI
120 PSI
8 PSI
1 bar = 100 KPA
value
light and
RANGE
0-55 PSI
0-120 PSI
0-120 PSI
0-15 PSI