When proper pressure is reached, turn off
appliance. Remove the adapter from the
inflated article and remove the adapter from the
connector.
TIPS
1.
When unscrewing the air hose, there would
be heat caused by a long-running at the
joint of the air hose and the interface. Do
not touch it.
2.
The air pressure of the balloon, swimming
ring, toy ball and other low pressure
products is the minimum pressure detection
range .
CHARGING
Battery 100%
Battery 80%
Battery 60%
The product cannot be used during charging.
1.
Insert the type-C USB end into the electric
air pump's charging port.
2.
Insert the USB charging lead into the
adapter's USB output port. Adapter is not
in set.
3.
During charging, the battery icon on the
display screen flickers.
4.
When the battery is fully charged, the
battery icon stops flickering.
The display screen goes out after 10 seconds
without operation. Short press the power button
to see the charging status.
USING AS USB POWER BANK
NOTE: Before connecting, always check the
voltage compatibility.
1.
Turn on the electric air pump.
2.
Insert the device's regular USB charging
lead into the USB output port.
3.
Connect the micro-USB end into the micro-
USB port of the device. Check the display
on the charging device to ensure charging is
taking place.
4.
When charging is completed or the battery
is low, the electric air pump automatically
turns off.
5.
After charging, always disconnect the
device and the charging lead from the
power bank.
LED LIGHTING
Press and hold the unit toggle / LED light button
to turn on/off the light.
REFERENCE TABLE
WARNING: Avoid over-inflating. Never exceed
recommended pressure. The item being inflated
may burst and cause serious injury. Below
table is for reference only. Consult your owner's
manual for exact pressure rating.
PRODUCT
10-16 inch bicycle
20-30 inch bicycle
Road cycling
Wheelchair booster
Motorcycle
Kid's toy ball
HOT
PRESSURE RANGE
Battery 30%
Battery 5%
30-45 PSI
38-55 PSI
90-120 PSI
30-45 PSI
28-55 PSI
2-6 PSI
EN
33