Operation - Defiant DFI-5996-WH Guía Para El Uso Y Cuidado

Operation

1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
3
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
Set the "ON-TIME" switch to the "TEST"
position.
Set the "DUALBRITE" switch to the "OFF"
position.
Slide the "SENS" switch to the "L" (low)
position.
2
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
A
8
Rotating the sensor controls
downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
C
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
1 MIN
C
TEST
L M
6H
OFF 3H
5 MIN
20 MIN
ON TIME
H
SENS.
DUSK TO DAWN
DUAL BRITE