Examine Extension Cables; Transportation And Storage; Move The Machine; Store The Machine - GreenWorks BVA802 Manual Del Operario

EN
5.5

EXAMINE EXTENSION CABLES

• Look carefully for deterioration, cuts or cracks in the
insulation.
• Examine the plug for damage.
• Replace cables if defective or damaged.
6 TRANSPORTATION AND
STORAGE
Disconnect the plug from the power source before
tranportation and storage.
6.1

MOVE THE MACHINE

• Only hold the machine with the handgrip.
6.2

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
7

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The tube has block-
ages.
The impeller has
blockages.
The bag is full.
The machine
does not The bag is dirty.
blow or
The bag has dam-
mulch.
age.
The bag is unzip-
ped.
The unit is discon-
nected.
WARNING
SOLUTION
Make sure that the
tube is clear.
Make sure that the im-
pller is clear.
Empty the bag.
Clean the bag.
Replace the bag.
Lock the bag.
Connect to an outlet or
an extension cable.
English
PROBLEM POSSIBLE
CAUSE
The on/off button is
in the OFF position.
The on/off button is
defective.
The machine
The tube is not in-
does not start.
stalled correctly.
The gate is not
locked.
The unit is discon-
nected.
8

TECHNICAL DATA

Voltage
Frequency
Input Power
Air volume
Air speed
Weight
Measured sound pressure level
Guaranteed sound power level
Vibration
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
6
SOLUTION
Push the on/off button.
Replace the defective
parts by an approved
service centre.
Make sure that you in-
stall the tube correctly.
Make sure that you
lock the gate.
Connect to an outlet or
an extension cable.
220 - 240 V
50 Hz
2800 W
11 - 14 m³/min
270 - 320 km/h
4.5 kg
L = 92.5 dB(A), K =
PA PA
2 dB(A)
L = 110 dB(A)
WA.d
2 2
4.6 m/s , K = 1.5 m/s
Double-insulated con-
struction