Velleman AM6621 Manual Del Usuario página 2

RECEIVER FOR REMOTE CONTROL DEVICE
This receiver designs to remote control garage door, engine start, trunk release motor,
turns on/off light & other.
1. Locate a float surface and use the module as a template to drill two holes required for a
secure mounting.
2. Using the provided screws to secure the control module to the mounting surface.
NOTE : The control module should keep away from high humidity area, large metal
objects and other radio frequency modules.
1. Antenna placement is very important! Ensure it is unwrapped and stretched out at least
6" straight and keep it away from metal objects.
2. The remote distance determined by the location of the control module. Metal near the
receiver will shorten the remote distance.
1. Adapter wire:
(1) Black wire -- system ground, connect this wire to the negative ground point.
(2) Black with white trace wire -- system power, connect this wire to a permanent +
12VDC live point power.
Note : For home electric appliances an optional AC to DC adapter is required (the
output spec. Is 12VDC and at least 300mA)
2. Two wire harness : grey wire and white wire.
White Wire
Grey Wire
+ 12V or Ground Depending
on System Requirement
OPERATING MANUAL AM6621
INSTRUCTION
MOUNTING THE REMOTE MODULE
RF ANTENNA -- BLACK WIRE --
WIRING
White Wire
Grey Wire
Remote Control
Engine Start,
Signal Input Wire
Trunk Release
Light On/Off, &
Other Devices
Electric Garage Door or
Community Gate Control Switch
To Electric Garage Door
or Community Gate Control Device