Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installation of the Projector and Screen
Install the projector in a suitable environment according to instructions of the
accompanying manual "SAFETY INSTRUCTIONS" and this manual.
Refer to the drawing and table below for determining of the screen size and projection distance.
TOP VIEW
b
SIDE VIEW
a
Installation of liquid crystal projector
Please basically use liquid crystal projector at the horizontal position.
If you use liquid crystal projector by the lens up position, the lens down position and the side up
position, this may cause the heat inside to build up and become the cause of damage.
Be especially careful not to install it with ventilation holes blocked.
Angle Adjustment
Use the foot adjuster on the bottom of the projector to adjust the projection angle. It is variable
within 0˚ to 10˚ approximately.
Foot Adjuster
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
1. Lift up the front side of the projector, and pressing
the foot adjuster button, adjust the projection angle.
2. Release the button to lock at the angle to be fixed.
3. Turn the rear foot adjuster to adjust the left-right slope.
Do not release the foot adjuster button unless the projector is being held; otherwise, the
projector could overturn or the fingers could get caught and cause personal injury.
a: Distance from the LCD projector to the screen.
The projection distance shown in the table below
are for full size (800 x 600 dots).
b: Distance from the lens center to the bottom of the
screen (a, b: +/-10%)
Table 1. Installation Reference
Screen size
(inches)
Press the foot adjuster button
a (inches)
Min.
40
37
60
57
80
77
100
96
120
116
150
145
200
194
Rear
b (inches)
Max.
46
3
69
5
93
7
116
9
139
10
174
13
233
17
Foot Adjuster
ENGLISH-5
Publicidad
Tabla de contenido
