Attention! The factory dashboard trim panel
and sub-dash will have to be cut to allow the
aftermarket radio to fit.
1. Remove the climate controls from the
factory dash panel.
2. Place the cut template over the panel
and mark areas to be cut and the four
holes to be drilled. (Figure A)
3. Using a 1/4 inch drill bit, drill the four
holes marked from the template.
4. With a cutting tool, enlarge the dash
panel opening so the radio trim panel
fits. (Figure B)
KIT PREPARATION
(Figure A)
Remove shaded area
(Figure B)
5. Place the radio trim panel onto the dash
panel and secure from the back with the
(2) retaining brackets and the included
(4) #4 x 3/8" screws. (Figure C)
6. Remove the two screws at the back of
the radio tray. Cut the area shown from
the sub-dash to provide the room for
the aftermarket radio. (Figure D)
Continue to Kit Assembly
(Figure C)
Remove screws
and shaded area
(Figure D)
REV. 8/11/2021 INST95-6557B
3