BOERBOEL GardDog Instrucciones De Instalación página 3

Mounting the Upright Handles:
1
a.) Once hinges are installed and gate is aligned, place
the alignment template on the gate upright at the
desired height.
NOTE:
Use the 1
or 2" template for 2" gate uprights.
Ensure the two solid lines of the template are
positioned at the outer edges of the gate upright
(Fig. 1).
b.) Pre-drill two corner holes using a
pre-drill one center hole using a
on opposite side of upright (Fig. 2).
c.) Remove and discard templates.
d.) Insert the three prongs of the front handle through
the three pre-drilled holes on the front side of the
upright (Fig. 3).
NOTE:
If using a 1
spacer. 2" uprights do not require the spacer.
The remainder of this manual shows the
installation using the spacer.
e.) Align the spacer on the rear face of the upright
though the three prongs of the front handle (Fig. 4).
f.) Install the rear handle by guiding the at bar of
the front handle into the slotted groove of the rear
handle (Fig. 5).
⁄ ⁄ " template for 1 ⁄ ⁄ ⁄ " gate uprights, ⁄ ⁄ ⁄
1 1 1 1 1 1
2 2 2 2
1 1 1
⁄ " upright, you will use the included ⁄ ⁄ ⁄
1 1 1
2 2
⁄ ⁄ " drill bit and ⁄ ⁄
1 1 1
4 4
⁄ " drill bit. Repeat ⁄ ⁄ ⁄
2 2
Front
Template
Front
1/4"
1/4"
3 Prongs
Front
Handle
Close-Up of Close-Up of
Rear Handle Rear Handle Rear Handle
shown for detail shown for detail shown for detail
Fig. 1
Solid Lines
Gate Upright
Fig. 2
1/2"
Fig. 3
Front
Handle
Front Front
of Upright of Upright
Fig. 4
Fig. 5
Flat Bar Flat Bar
Spacer not Spacer not
3