SOMFY 1810803 Guia De Instalacion página 6

COMMISSIONING
Before assign a product to the transmitter,
this product must be set.
Assign a product with a RS485 control
1) Press the programming button on the
back of the RTS control point or the RTS
receiver until the motor jogs.
The product is in programming mode.
2) Send by the RS485 control, the
corresponding RTS frame on the desired
channel.
The product is assigned to the transmitter's
channel with a motor jog.
Assign a product with a DRY CONTACT
control
1) Select the RTS adress on the Channel
selector corresponding to dry contact
connectors.
- The dry contact connector n°1 has per
default, the RTS address n°1
- The dry contact connector n°2 has per
default, the RTS address n°2
- .......
- .......
- The dry contact connector n°5 has per
default, the RTS address n°5
2) Press the programming button on the
back of the RTS control point or the RTS
receiver until the motor jogs.
The product is in programming mode.
3) Press the programming button on the
RS485 RTS transmitter until the motor jogs.
The product is assigned to the transmitter.
4 Copyright © 2009 Somfy SAS. All rights reserved - V0 - 09/2009