English; General Instructions; Safety Instructions; Application And Intended Use - Denios LD-SK Manual De Instrucciones

English

1. General Instructions

No changes, extensions or modifications may be made to the product without the manufacturer's
authorisation. No liability is accepted for changes made without the manufacturer's authorisation and in such
cases the warranty will cease to be valid.
National directives and safety regulations must be complied with.

2. Safety instructions

Before using the product, it should be checked to ensure it functions correctly. Should any defects appear, it
must not be used.
The German regulations BGV D8 (hoisting, lifting and winching equipment) and BGV D27 (industrial
trucks) must be observed.
Only use for the intended purpose.
The load must not be left in the raised position.
Drums may only be slightly raised (approx. 50 mm) during transported.
The specified load capacity must not be exceeded.

3. Application and intended use

Drum lifter LD-SK makes it easy to lift and transport various types of steel and plastic drums:
The user must ensure that the equipment is suitable for the actual drums to be transported.
The floor must be flat, even and solid.

4. Technical Description

Model
Item no.
Drum lifter is constructed as follows:
stable frame with lifting mast
-
adjustable drum clamp
-
- hydraulic pump with lifting cylinder
2 swivel castors and 2 fixed castors
-

5. Setting up and initial operation

Drum lifter with hydraulic pump:
Before using the drum lifter for the first time, loosen the oil screw on the hydraulic
cylinder and raise the lifter with a load on board so that the air is removed from the
hydraulic system. Afterwards tighten the oil screw again. This method can also be
used for removing any air bubbles in the hydraulic system in the future.
If the oil screw is replaced with a screw with a hole (possibly included in the
delivery), the hydraulic system is permanently bled.
Fasslifter LD-SK
201867
- 205 – 230L steel channel drum in accordance with EN 15750-2
- 208 – 216.5L steel lidded drum in accordance with EN 15750-1
- 220L plastic lidded drums
- 220L plastic L ring drums
LD-SK
201867
Seite 6 von 15 Seiten Ausgabe 11/2013