Steelcase Groupwork Serie Manual De Instrucciones página 4

®
9.
For all table sizes except 24" x 36", slide 4" x 4" x 1/16" cardboard spacer
under each bend in linkage bar. One spacer is required on 24" x 42" and 30" x 36"
tables (9a); two are required on longer tables (9b).
NOTE: 1/16" thick spacers are provided as an assembly aid to offset linkage bar
from worksurface. The offset helps prevent damage to linkage bar finish when
folding and unfolding table.
10.
For 24" x 42" and 30" x 36" tables (these two sizes have single bend in
linkage bar), adjust both ends of linkage bar to approx. 10" from underside of worksurface.
11.
For 24" x 36" table, lift linkage bar and place 4" x 4" x 2-1/2" cardboard spacer in
approx. center of worksurface (11a). Lower linkage bar onto spacer and adjust both
ends of linkage bar to approx. 9-3/4" from underside of worksurface (11b).
NOTE: 2-1/2" thick spacer is provided as an assembly aid to offset linkage bar from
worksurface. The offset is required to provide clearance to leg base plate when table is
folded (11c). Damage to linkage bar could occur if it contacts the plate.
NOTE: Spacers should not be removed until table assembly is complete (see pg. 6).
24" X 36" TABLE
11b
9-3/4"
2-1/2" THICK
SPACER
11c
9-3/4"
11a
TWO 1/16" THICK SPACERS
USED ON LONGER TABLES
24" X 36" TABLE
FOLDED
SPACER PROVIDES
CLEARANCE WHEN
TABLE IS FOLDED
9a
9b
ONE 1/16" THICK
SPACER USED ON
24" X 42" & 30" X 36"
TABLES
10
10"
LINKAGE BAR END DIMENSION FOR
24" X 42" & 30" X 36" TABLES
10"
Page 4 of 24
1051162001 Rev G