Before Returning For Repairs - Schumacher Electric SWI-1224 Manual Para El Propietario

PROBLEM
Short or no start cycle when
cranking engine.
Charger will not turn on when
properly connected.
The battery is connected and
the charger is on, but is not
charging.
17.

BEFORE RETURNING FOR REPAIRS

17.1 When a charging problem arises, make certain that the battery is capable of accepting a
normal charge. Double check all connections, AC outlet for the correct voltage, charger
clips for correct polarity and the quality of the connections from the cables to the clips
and from the clips to the battery system. The clips must be clean.
17.2 When a battery is very cold, partially charged or sulfated, it will not draw the full rated
amperes from the charger. It is both dangerous and damaging to a battery to force
higher amperage into it than it can effectively use in recharging.
17.3 When an UNKNOWN OPERATING PROBLEM arises, please read the complete manual
and call the customer service number for information that will usually eliminate the need
for return.
Schumacher and the Schumacher Logo are registered trademarks of
POSSIBLE CAUSE
Drawing more than the Engine
Start rate.
Failure to wait 3 minutes (180
seconds) between cranks.
Clips are not making a good
connection.
AC cord and/or extension cord
is loose.
No power at receptacle.
The charger may be
overheated.
Battery may be severely
discharged.
AC outlet is dead.
Poor electrical connection.
Clips are not making a good
connection.
Schumacher Electric Corporation
• 43 •
REASON/SOLUTION
Crank time varies with the
amount of current drawn. If
cranking draws more than the
Engine Start rate, crank time
may be less than 3 seconds.
Wait 3 minutes of rest time
before the next crank.
Check for poor connection at
battery and frame.
Check power cord and
extension cord for loose fitting
plug.
Check for open fuse or circuit
breaker supplying AC outlet.
The thermal protector may have
tripped and needs a little longer
to reset. Make sure the charger
vents are not blocked. Wait and
try again.
On a severely discharged
battery, charge for 10 to 15
minutes in the 30 amp charge
rate to help assist in cranking.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for loose fitting
plug.
Check for poor connection at
battery and frame. Make sure
connecting points are clean.
Rock clips back and forth for a
better connection.