Remote Control Battery - Eton SOUND 140 CONCERTO El Manual Del Propietario

REMOTE CONTROL BATTERY

The remote control battery has been previously installed and is ready
for operation. When the remote control stops functioning, you must
replace the battery with a new one. To do so, locate the battery com-
partment on the bottom of the remote and follow the steps below:
1. Squeeze the small notch while pulling the 'battery door latch ' out
towards you. This will allow the battery holder to release and pop
out.
2. Insert a CR2025, 3V lithium battery. Make certain to follow the
correct polarity, following the directions of the corresponding
symbols (+/-).
3. Secure the battery and push the battery holder back into the
remote control until fully inserted.
LOCATION OF CONTROLS ON THE MAIN UNIT
Front Panel:
A) Knob (Multi-Function)
B) Sleep
C) Source
D) Play/Pause
E) Set

SOUND 140 OWNER'S MANUAL
F) Tune +
G) Tune –
H) IR sensor
I) Light sensor