Maintenance; General Cleaning And Maintenance Instructions; Exhaust System - Samsung FlexDry DVEG60A9900 Serie Manual Del Usuario

Maintenance

Keep your FlexDry™ dryer clean to prevent decreased performance and to lengthen its life.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing.
Service Personnel - Do not contact the following parts while the appliance is energized: Control board and
inlet valve.

General cleaning and maintenance instructions

Control panel
• Clean with a soft, damp cloth. Do not use abrasive substances.
• Do not spray liquid cleaning agents directly on the display of the dryer.
• Some laundry pre-treatment soil and stain removers may damage the control panel.
• When using liquid cleaning agents, apply them to the cleaning cloth. Do not apply them directly to the
dryer. Wipe up any spills or overspray immediately.
Exterior
• Clean with a soft, damp cloth. Do not use abrasive substances.
• Protect the surface from sharp objects.
• Do not place heavy or sharp objects or a detergent container on the dryer. They can scratch or damage
the top cover of the dryer.
• The dryer has a high-gloss finish on its entire surface. Be careful not to scratch or damage the surface.

Exhaust system

• Check and clean the exhaust system on a yearly or regular basis to maintain optimum performance.
• The external exhaust hood must be cleaned more frequently to ensure proper air flow.
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the ductwork. Check
the following if you get the "Check the lint filter or vent condition" message when you turn on the dryer.
NOTE
• For duct installation, see Exhaust ducting guide on page 33 and Ducting requirements on page 16.
• The dryer may keep running even if the duct is clogged, but the drying time will be extended.
• When you get the message check the lint filter and the ducts, and clean them if necessary.
• If the message keep appears, it is because the duct is installed or connected with some restrictions (it's
too long or has too many bends). This is not a system failure. However, drying time may be extended or
the drying performance may be degraded.
Untitled-5 59
English 59
2021-05-25 5:20:44