Installing The Axxess Interface; Initializing The Axxess Interface; Vehicle Customization With The Optional Ax-Lcd - Metra 99-3309B-LC Instrucciones De Instalación

Installing the Axxess interface

With the key in the off position:
• Connect the 3309B-LC harness into the interface, and then to the wiring harness
in the vehicle.

Initializing the Axxess interface

Attention: If the Axxess interface loses power for any reason,
the following steps will need to be performed again.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off
position, disconnect the interface, check all connections, reconnect the interface,
and then try again.
• Turn the key to the off position, and then to the accessory position.
• Test all functions of the installation for proper operation, before reassembling the dash.
99-3309B-LC
Vehicle customization with the
optional AX-LCD
The AX-LCD allows the retention of the vehicles personalization menu that is lost
after removing the OE radio.
From the DIN harness with leads on the AX-LCD harness:
• Connect the Black wire to ground.
• Connect the Red wire to accessory power.
• Connect the Pink wire to the Pink wire of the 3309B-LC harness.
Note: This wire will have to be soldered onto the 3309B-LC.
• Tape off and disregard the Blue/Pink wire, it will not be used in this application.
• Press and hold the "Return/ESC" button on the LCD screen for 5 seconds until
"Select Interface" comes up.
• Select "Connection Type", and then press "Enter"
• Scroll up or down to "Gateway", and then press "Enter"
• Once done, press the "Return/ESC" button two times to get back to the main menu.
5
(sold separately)