Michelini TURBO MULTIFUNZIONE PULIZIA/STIRO INOX Manual De Uso página 17

EN
SAFETY RULES
· Do not fill in the boiler directly from the tap, but use the funnel delivered.
· It is recommended to use distilled water on all aluminium boilers to prevent excessive f
ouling. Use normal tap water for copper boilers.
· Do not overfill the tank and do not pour in it any stain-removing mix or chemical agents,
in general, except for products specified in the BOILER CLEANING section.
· Avoid any impact to the product as it could be damaged.
· Do not use the iron like a heating unit.
· Keep the electric cable (5) free from knots and/or twists and unwind in its full length before
connecting with the electric mains.
· When removing plug (5) from socket , do not pull the cable, but hold the plug itself.
· Do not wind the electric cable around the iron, nor take it close to the boiler plate or,
for TURBO STEAMER, to cleaning accessories.
· In case of damage to single-pipe (11), have the faulty cable immediately replaced by an
authorized Technical Support Centre.
. Cleaning operations are to be performed with plug disconnected only. In case of damage
to power supply cable or plug (5), have the faulty cable immediately replaced by an authorized
Technical Support Centre.
· In case of damage to steamer hose (20), have it immediately replaced by an authorized
Technical Support Centre.
· Do not attempt to personally act on the appliance, but only perform operations shown on
the manual.
· When the appliance cannot be used any more at its life end or you decide not to repair it
in case of malfunction, cut the power supply cable to make it unusable.
· The non compliance with the above can affect the appliance safety and make the warranty void.
ATTENTION RISK OF ELECTROCUTION DO NOT EXPOSE TO
RAINAND HUMIDITY THE PRODUCT CONTAINS 230-V
OPERATING COMPONENTS, DO NOT OPEN IN ANY CASE.
ATTENTION DANGEROUS TEMPERATURES - THE IRON PLATE BECOMES VERY HOT
BE CAREFUL NOT TO GET BURNT. DO NOT PUT YOUR FACE CLOSE TO THE STEAM
GETTING OUT OF PLATE ORCLEANING ACCESSORIES.
MODELS WITH STEEL STRUCTURE TEND TO HEAT MORE THAN PLASTIC VERSIONS.
SO DO NOT TOUCH MACHINES WHEN ON AND STOW THEM WHEN COMPLETELY
COOLED DOWN.
ATTENTION READ CAREFULLY ALL INSTRUCTIONS BEFORE USING
THE APPLIANCE DO NOT PERSONALLY REPAIR THEM, BUT ONLY CONTACT
AN AUTHORIZED SUPPORT CENTRE.