Bosch PFS 65 Manual Original página 22

22 | English
An even movement of the spray gun results in an
even surface quality.
Non-uniform clearance and spray angle lead to
heavy formation of paint mist and thus to an un-
even surface.
– End the spraying procedure outside the tar-
get area.
Never spray the container completely empty.
When the suction tube no longer immerses in
the spray material, the spray jet will break off,
resulting in a non-uniform surface.
When coating material builds up on the nozzle
and air cap, clean both parts with the corre-
sponding solvent.
Adjusting the Spray Pattern (see figure F)
Never actuate the trigger switch 9 while ad-
justing the air cap 2.
– Loosen the union nut 3.
– Turn the air cap 2 to the requested position.
– Firmly retighten the union nut.
Air cap Jet
Adjusting the Spraying Capacity (see figure G)
– To adjust the requested spraying capacity,
turn the thumbwheel 5:
I: Min. spraying capacity,
IIII: Max. spraying capacity.
1 609 929 R18 | (7.5.09)
Application
A
Vertical flat jet for
horizontal working
direction
B
Horizontal flat jet for ver-
tical working
direction
C
Round jet for corners,
edges and hard to reach
locations
Spraying capacity
Too much material on
target area:
Not enough material on
target area:
Placing down the Spray Gun (see figure H)
For breaks, the spray gun can be hung in the
holding clamp 16.
– Hang the spray gun with the union nut 3 into
the holding clamp 16.
Adjustment
The spraying
capacity must be
reduced.
– Turn the thum-
bwheel 5 in
direction I.
The spraying
capacity must be
increased.
– Turn the thum-
bwheel 5 in
direction IIII.
Bosch Power Tools