Worx WX333 Manual Original página 10

9. DRILLING FUNCTION (See Fig. G, H)
1)Press the lock button (A) and rotate the
selector switch to make sign "
the triangle. (See Fig. G)
2)Turn the hammer or drilling action selector
switch pointing to the drilling action " "
position. (See Fig. H)
3)You are now set up for drilling function.
10. CHISEL FUNCTION (See I, J)
1)For chipping, grooving or demolition
operation, press the lock button (A) and then
rotate the selector switch make sign "
pointing to the triangle. (See Fig. I)
2)Turn the hammer or drilling action selector
switch pointing to the hammer action "
position. (See Fig. J)
3)You are now set up for chisel work using
Chisel action.
WARNING: You must make
sure that the selector switch
is positively locked in chisel mode
position. If not, it could cause a hazard.
11. DUST COVER (See Fig. K)
10
Use the dust cover to prevent dust from
falling over the tool and on your self when
performing overhead drilling operations.
Attach the dust cover to the bit as shown in
the K.
12. LUBRICATION MACHINE (See Fig. L)
The machine is grease-lubricated. A grease
refill is only required during hammer work
efficiency is low. Open the grease box lid
at the top of the hammer using the pin
spanner provided. Then refill approx 30g
grease provided with your tool. The grease
specification is general purpose lithium based.
Use only Worx genuine hammer grease
(optional accessory).
CAUTION: Keep the container of grease
away from children.
13. TO REPLACE THE BRUSHES
(See Fig. M, N)
Disconnect the plug from the power supply.
Unscrew the carbon brush cap with
screwdriver.
Remove the carbon brush. Check the length
Rotary Hammer
of the brush and replace if under 6mm. When
brushes need replacement always renew both
brushes, even if one is still more than 6mm
" point to
long.
Completely screw down the carbon brush cap.
Check that the tool is working. Before use,
allow it run for a few minutes to enable the
brushes to settle.
WORKING HINTS FOR
YOUR TOOL
"
1. Reduce the pressure on the drill bit when it
is about to break through. This will prevent
the drill from jamming.
"
2. When drilling a large hole, first drill a pilot
hole using a smaller drill bit.
3. Always apply pressure to your drill bit in a
straight line, and if possible at right angles
to the workpiece.
4. Never change the operating mode whilst
the drill is running.
5. Do not apply excessive pressure to the tool
when chiseling. Expressive force does not
speed up the work.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
EN