Setting Up The Grinder; Electrical Connection; Grounding Instructions - Oregon 520-120 Instrucciones Originales

SAFETY INFORMATION
The table below shows the correct size to use
depending on cord length and nameplate ampere
rating If in doubt, use the next heavier gauge The
smaller the gauge number, the heavier the cord
Minimum Extension Cord
Gauges for 520-120 Grinder
Length
25 ft / 7 6 m
50 ft / 15 2 m
100 ft / 30 5 m
150 ft / 45 7 m
NEVER LEAVE TOOL RUNNING UNATTENDED
Turn power off Do not leave tool until
it comes to a complete stop

SETTING UP THE GRINDER

CAUTION The grinder must only be used in a
place that is protected from dust and dampness,
is well-lit, out of the reach of children, and away
from gases or other flammable or explosive liquids
The grinder must be situated near a
normal grounded electrical outlet Avoid
using dangerous extension cables

ELECTRICAL CONNECTION

– Make sure the electrical system power
supply complies with the values
written on the rating nameplate
– The power supply voltage must not differ
from that written on the nameplate by ±5%
– The connection to the electric mains must be
prepared subject to current standards in force
in the country in which the machine is used
– The power socket used for the machine must be
grounded, have an adequate fuse, and must be
protected by a ground fault protection device
with tripping sensitivity no higher than 30 mA
FIG. A
Cover of
grounded
outlet box
8
Gauge, AWG
18
16
16
14
FIG. B
Grounding
Pin

GROUNDING INSTRUCTIONS

A. In the event of malfunction or breakdown,
grounding provides a path of least resistance
for electric current to reduce the risk of electric
shock This tool is equipped with an electric cord
having an equipment-grounding conductor and
a grounding plug The plug must be plugged
into a matching outlet that is properly installed
and grounded in accordance with all local
codes and ordinances Do not modify the plug
provided – if it will not fit the outlet; have the
proper outlet installed by a qualified electrician
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock
The conductor with insulation having an outer
surface that is green with or without yellow
stripes is the equipment-grounding conductor
If repair or replacement of the electric cord or
plug is necessary, do not connect the equipment-
grounding conductor to a live terminal
Check with a qualified electrician or service
personnel if the grounding instructions are
not completely understood or if in doubt as
to whether the tool is properly grounded
Use only 3-wire extension cords that have
3-prong grounding plugs and 3-pole receptacles
that accept the tool's plug Repair or replace
damaged or worn cord immediately
B. Grounded, cord-connected tools intended for
use on a supply circuit having a nominal rating
less than 150V~ This tool is intended for use on
circuit that has an outlet that looks like the one
illustrated in FIG A The tool has a grounding
plug that looks like the plug illustrated in FIG B A
temporary adapter, which looks like the adapter
illustrated in FIG C, may be used to connect this
plug to a 2-pole receptacle as shown if a properly
grounded outlet is not available The temporary
adapter should be used only until a qualified
electrician can install a properly grounded outlet
The Grounding Means green-colored rigid ear,
lug, and the like, extending from the adapter
must be connected to a permanent ground
such as a properly grounded outlet box
FIG. C
Adapter
Grounding
Means
Cover of grounded
outlet box
520-120
Metal
Screw