Tripp-Lite 2POSTRMKITMB Instrucciones De Instalación página 2

1
Using the included thumbscrews, attach the PDM
Mounting Brackets to the PDM.
Note: Do not tighten screws at this time.
1
PDM Outlet Configuration will Vary by Model
3
Attach the PDM assembly to the 2-Post Brackets. The
PDM bracket's built-in hooks provide temporary support
while securing the PDM to the rack with the permanent
mounting hardware.
Note: PDM Mounting Brackets can be laterally adjusted to
ensure a proper connection between the UPS and PDM. To
adjust the brackets, loosen the thumbscrews. Fully extend the
PDM to the end of the brackets. Do not tighten screws at this
time. Refer to step 6 for more information.
3
PDM Outlet Configuration will Vary by Model
2
Attach the (two larger) 2-Post Brackets to the rear of the
2-Post Rack.
2
4
Attach the (two smaller) 2-Post Brackets to the front side
of the 2-Post Rack.
4
2