Wolf Garten Lycos 40/400 M Manual De Instrucciones página 28

EN
Removing and emptying the grass collector
(Fig. )
If grass cuttings are left lying on the ground or the
yellow STOP sign of the ll level indicator is visi-
ble , the grass collector is full and you should
empty it immediately
Risk of injuries due to the rotating mower
blade.
Only adjust the lawnmower with the
motor switched o and the mower blade
at a standstill.
Switch the motor o .
SAFETY ROUTINE
Open the cover
Turn the safety key anti-clockwise until it reaches
position "0" .
Press the power pack release
Put the power pack into position 1
storage and transport.
Close the cover
Raise the de ector ap
Remove the grass collector
Lower the de ector ap again
Empty the grass collector
Before starting, clear any blockages in the mowing
chamber .
Fill level indicator information (Fig.
The ll level of the grass collector is indicated by
the position of the ap of the ll level indicator.
• If the grass collector is empty, the ap of the ll
level indicator points upwards
• If the grass collector is full, the ap of the ll
level indicator points downwards and the yellow
STOP sign is visible
The grass collector must be emptied immediately
.
To ensure trouble-free operation of the ll level
indicator, regularly clean the area beneath the ll
level indicator on the inside of the grass collector
using a hand brush
28
.
DANGER!
.
.
for
.
.
.
.
.
)
.
.
.
Working without a grass collector
Take the grass collector o .
The de ector ap folds down.
Note
hen wor ing without the grass collector,
the grass cuttings are thrown downwards.
Mulching (Fig. )
During mulching, the grass is cut multiple times
using a special cutting system and fed back into
the ground. This means there is no grass waste.
Moreover mulching protects the lawn against drying
out. The mulched grass contains lots of nutrients.
To obtain optimum results, the grass must be kept
short. ou can nd more information in the section
"Lawn care tips .
Note
Depending on the growth of the grass, we
recommend mulching 1 –
doing so the grass must not be too long or
too moist!
When mulching, push the lawnmower slowly.
Also ensure that the cutting stripes always
overlap.
Do not cut more than 20 mm of grass.
Note
If the lawn is moss or contains lots of
thatch, mulching is not worthwhile because
the grass cuttings remain on the surface of
the moss or thatch and thus cannot be fed
into the ground.
Dethatch and fertilize the lawn regularly.
Activating the MULCH function (Fig.
Risk of injuries due to the rotating mower
blade.
Only adjust the lawnmower with the
motor switched o and the mower blade
at a standstill.
The lawnmower is equipped with a
changeover switch (cut-collect/mulch). .
Use this switch to choose between the
functions cut-collect and mulching for
your lawn care.
per wee .
DANGER!
Operation
hen
)