Time Setting; Countdown Timer - Technoline KT-300 Manual De Usuario

Replace battery compartment cover. The product briefly shows all the display segment

4. Installation:
The timer has a magnet for attaching it to metal surfaces; it also can be placed onto any flat surface by

the foldable stand (C2) on the back of the housing, Or wall mounted by the hanging hole ( C1 ) at the
back of the unit.

5. Time Setting

5.1 Time Setting
Ensure that the clock display is showing in the display.
If necessary press the "CLOCK/TIMER" (B6) Button to change the display
Hold "CLOCK" (B6) button for 3 seconds until the time of day display flashes in the upper display panel,

and enter to time setting mode.
Use the "HR" button（B7） "MIN" button （B8） and "SEC" button（B9）to set the current time. Keep

the button pressed to accelerate the change in value.
Press "CLOCK" (B6) button to finish the setting process and save the set time of day.

5.2 12/24 Time Format:
The time of day can be displayed either in 24- or 12-hour mode. Press "(12/24)" button (B8) to select

12 or 24 hours format.
In the 12-hour mode, the morning hours are shown with AM and the afternoon hours with PM.

6. Timer
6.1 Count Up Timer
At time display mode, press "START/STOP" (B4) button to start count up

Press "START/STOP" (B4) button in the time display mode again, to stop the count-up timer.

Press "CLEAR" (B5) button in stop status, the count up timer will reset to "0".


6.2 Countdown Timer

Real time display mode
→
Timer display mode