Technoline KT-300 Manual De Usuario página 8

6.2.1 Setting Countdown Timer:
TIMER 1, 2 and 3 must be displayed. Press "CLOCK/TIMER", if necessary.
Hold " T1 (T2 or T3)" button until the numbers begin to flash

Use HR (hours), MIN (minutes), SEC (seconds) to set the timer.

Press "CLEAR" button reset to zero.

Press T1 (T2 or T3), to confirm and finish the setting, the timer display stop flashing

NOTE:
A countdown cannot last longer than a maximum of 19 hours, 59 minutes and 59 seconds.

You can set up to 3 countdowns. They can be stopped and started either simultaneously or staggered.

While you set times to be measured, no other settings can be made (For example toggle to time of day

etc.)
6.2.2 Countdown function
Timer function in countdown mode is carried out in the same way in all TIMER1, 2 &3 displays
Press "T1" (B1) to start / stop the countdown function of TIMER1.

Press "T2"(B2) to start / stop the countdown function of TIMER2

Press "T3"(B3) to start / stop the countdown function of TIMER3

When all timer in stop status, Press "START/STOP" (B4) button to start or stop all the timers (T1, T2 & T3)

in same time. (When one of the timer is running, this function is not available)
6.2.3 Countdown Timer Alarm
When the timer counts to zero, a signal sound will emit for around 1 minute, the icon "TIME'S UP" will

flash on the display.
Press "START/STOP" or the corresponding key (T1, T2 or T3) to deactivate the alarm sound.

6.2.4 Reset Countdown Timer
When the countdown timer in stop status, press "CLEAR" (B5) button to reset them to zero.

If one of the timer is still running, it will only reset for other timer, for example, Timer1 is running and

Timer2 & Timer3 are in stop status, only Timer2 & 3 will reset to Zero after pressing "CLEAR" (B5)
button. Timer1 will keep count down.