Installation Instructions - Presto Robinet P1000 XL A Instrucciones De Instalación

ENGLISH

1) INSTALLATION INSTRUCTIONS

2) P1000 XL A/P1000 XL E Flush valve ND20 - G3/4 EN 12541 compliant
3) PRECAUTIONS FOR USE (The product guarantee depends on the respect for these rules)
INSTALLATION and START UP
For products delivered with filters, these must be installed in accordance with the instructions.
Before commissioning any of our valves, it is essential to carefully drain
the pipes which can damage the mechanisms or water passages (PRESTO® heads
that can be dismantled from front).
Recommended operating pressure according to NF EN 816: 1 to 5 bars.
CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned only with soapy water.
Abrasive, acid, alkaline or ammonia-based household products are prohibited.
4) Part no. 14250 Complete P1000 XL A concealed flush valve, front plate ABS ivory finish
5) Part no. 14251 Complete P1000 XL E concealed flush valve, front plate vandal-proof stainless steel
6) Technical characteristics:
- Connection male thread G3/4"
- 1/4 turn stop valve
- Automatic flow limiter.
- Adjustable supply volume from 6 to 9l. (Supplied set to 6l) (P1000 XL version)
- Outlet connector for 28x2 dia. PVC tube (part no. 47850).
7) Part no. 14231 P1000 XL A Front plate ABS ivory finish
8) Part no. 14233 P1000 XL E front plate, stainless steel (vandal-proof)
9) Part no. 14241 - concealing box, P1000 XL Class II
10) Installation
11) Flush tube Part no. 47850 not supplied
12) Flush tube Height 500 mm minimum
13) Installation of the concealing
14) Bleed the installation before installing the valve
15) Left or right inlet
16) Sealing
17) Torx No. 15 screwdriver
18) Protection plate
19) Tiles
20) Installation of P1000 XL A and P1000 XL E front plate
21) Green or black tube Ø4 - Lg = 0.25 m
22) 1 - Install the white tube as shown on the diagram
2 - Install the green or black tube
23) Connect on inlet arrow
24) White tube - Ø4 - Lg = 0.25
25) White tube connection
26) Connect on outlet arrow
27) Adjustment of the flow rate for P1000 XL (P min =1.2 bars) (P max = 4 bars)
28) Volume
29) Volume (litres)
30) Number of turns
31) Flow rate (l/s)
32) Flow rate diagram
33) Pressure (bars)
34) ABS ivory front plate – Part no. 14231
35) Stainless steel front plate – Part no. 14233
36) In the event of an anomaly, remove the cartridge and rinse in clean water
37) Dismantling the valve
38) Break the tab
39) Spare parts for P1000 XL Class II - cartridge – Part no. 01270
- Hydraulic trigger P1000 XL CP – Part no. 90930
40) P1000 XL CP trigger Part no. 90930
41) Replacing the cartridge
42) Cartridge + seals Part no. 01270
43) Foolproof location of the cartridge in the body
44) For the adjustment of the volume see chapter "Adjustment of the flow rate"
45) Foolproof location of the seal in the cartridge
46) This document is not contractual; we reserve the right to modify the characteristics
of our products without notice.
47) PATENTED and REGISTERED MODELS