Cequent Performance Products PRO Serie Manual De Instrucciones

Please read all instructions carefully before assembly, installation and/or use of this product.
WARNING: The Maximum capacity is 400 pounds. DO NOT EXCEED lowest of: vehicle mfg's, hitch weight carry
tongue weight, or cargo basket rating. Use with class 3 or higher 2" receiver hitch.
WARNING: Keep all body parts away from ramp sections when opening and closing ramp.
WARNING: Not for transport of people, animals, or flammable liquids.
WARNING: Do not ride equipment up ramp.
WARNING: Do not lubricate threads. Bolt failure may occur due to over tightening.
WARNING: Do not drill or weld to this product.
SPRING CLIP DETAIL
4
1
Qty. (1) Latch Arm
2
Qty. (5) Hex Bolt, 3/8-16 x 1.00 Gr5
3
Qty. (5) Hex Locknut, 3/8-16
4
Qty. (1) Spring Clip
5
Qty. (2) Screw, Self-Tapping #8
NOTE: This ramp is designed for use with cargo basket 1040100.
ASSEMBLY INSTRUCTIONS:
1. Attach the two halves of ramp with the 3/8 hex bolts and locknuts as shown above.
2. Tighten 3/8 bolts until snug and ramp sections swing freely.
WARNING: DO NOT PLACE ANY BODY PARTS BETWEEN RAMP SECTIONS WHEN OPENING OR CLOSING RAMP.
3. Install the lock pin, coil spring, flat washer, and lock nut into hole on side of ramp as shown.
4. Tighten the 1/4-20 locknut until there is approximately 5/8" between the flat washer and ramp tube – see lock pin detail.
5. Attach the spring clip in orientation shown using two #8 self-tapping screws – see spring clip detail.
Cequent Performance Products
47774 Anchor Court West
Plymouth, MI 48170
Technical Service: (888) 521-0510
7 8 9
5
Item:
Description:
2 3
6
6
Qty. (1) Lock Pin
7
Qty. (1) Coil Spring
8
Qty. (1) Flat Washer, 1/4
9
Qty. (1) Hex Locknut, 1/4-20
Page 1 of 3
1040200
CARGO RAMP
TOOLS REQUIRED:
7/16 Wrench
9/16 Wrench
Phillips Screw driver #2
5/8"
LOCK PIN DETAIL
1040200N REV D 10-14-09