Kohler K-T9540 Guia De Instalacion página 4

Confirm dot alignment.
Align three dots (center dot
should indicate bath fill).
2. Lever Handle Installation
Turn the transfer valve to the bath fill position (fully clockwise for
a two-way valve; center position for the three-way configuration).
Apply a bead of plumbers putty or other sealant around the
escutcheon flange according to the putty manufacturer's
instructions.
Position the escutcheon loosely on the valve so that the three dots
will be clearly visible after installation. The center dot should
indicate the bath fill position.
Temporarily position the knob on the valve to confirm proper
alignment of the dots.
Remove the knob and press the escutcheon firmly into place.
Remove any excess putty.
Position the lever handle onto the valve. If necessary, the pin may
be broken off the valve make aligning the handle easier.
Secure the lever handle to the valve with the screw.
Install the O-ring over the threads of the lever handle.
Snap the cap onto the handle so the dot lines up with the lever.
086840-2-AB
Cap
Screw
O-Ring
Lever Handle
Pin
Valve
Escutcheon
4 Kohler Co.