Elite IW440 Manual De Usuario página 29

TIGHTENING WHEEL NUTS
This impact wrench can be used to tighten wheel nuts and other fasteners.
1. Install the correct size of impact socket on the impact wrench (Fig. 1).
2. Place the wheel on the wheel studs and thread one wheel nut (1) clockwise onto each wheel stud (Fig. 3).
NOTE: Thread each wheel nut at least three full turns onto the wheel stud by hand to make sure the nuts are NOT
cross threaded. The wheel stud and wheel nut will be damaged if the nut is cross threaded.
3. Grasp the impact wrench handle with one hand and the front housing of the impact wrench with the other
hand.
4. Place the impact socket onto the lower wheel nut (1) (Fig. 4 & 5).
NOTE: Make sure the socket is fully engaged with the nut to avoid potentially damaging the socket or the wheel
nut.
5. While holding the tool level with the ground and with a rm grasp, squeeze the lower portion of the trigger
switch. The impact wrench will tighten the wheel nut.
TIGHTENING WHEEL NUTS – cont'd
NOTE: Release the trigger switch IMMEDIATELY when the impact mechanism "rattles".
6. Proceed with tightening the remaining wheel nuts as noted above.
10
www.ELITETOOLS.co
Keep Working