EHEIM 1260 Manual De Instrucciones página 9

C If the pump is used under water, it must only be operated using in the
built-in prefilter. For this purpose, cover the intake grille aperture with
the cap.
D For use out of water, the cap should be removed and replaced by the
screw-in intake adaptor.
Putting into operation
C When used in a pond, the pump must be placed on a firm base, e.g.
a paving slab. Do not place it on the soft floor of the pond.
D When used outside the water, the pump is started by priming at the end
of the pressure hose until water flows to the pump. Only then should
the power plug be plugged in.
The pump might emit a brief starting noise, which is normal.
Maintenance and servicing
E Disconnect the power supply. Remove intake grille (squeeze the pres-
sure points at the sides) and rinse coarse filter under running water
or replace. If the water is heavily contaminated, clean the filter fre-
quently.
Unscrew and remove the retaining ring and carefully pull the pump
cover straight out, taking care not to damage the fragile ceramic shaft.
Remove impeller with spindle.
Thoroughly rinse all parts under running water and clean with set of
EHEIM brushes (order no. 4009580). Reassemble in reverse order.
Fountain pump 3260010 and 3264010
Model: see type plate on pump housing
Similar to 1260010 with 10 m cable for underwater operation.
F complete pump
Screw in rising pipe on pressure side and install nozzle head. Height of
jet approx. 2 m.
Universal pumps 1260210 and 1262210
Model: see type plate on pump housing
Safety instructions
The Universal pumps 1260210 and 1262210 are suitable for indoor
use only.
Similar to 1260010, but with 1,7 m cable. For use also with marine water.
Without carrying handle.
Not suitable for outdoor use, neither in swimming pools nor garden ponds.
G The mounting plate can be installed on three sides of the pump to fa-
cilitate installation.
adapter riser pipe
- not suitable for outdoor use -
nozzle.