Wet/Dry Vac Assembly; Insert Hose - RIDGID RV2400HF Montaje

Wet/Dry Vac Assembly

1. Position the power head assembly on
the drum assembly as shown
(assembled earlier).
NOTE: Make sure the gasket on the
power head and the sealing surface on
the drum are not damaged and are clean
and free of debris
2. Hook the latches over the tab on the
power head assembly. Press the
latches down until they snap closed
against the sides of the drum.
Drum
Latch

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the Vac. The
hose should snap into place. To remove
the hose from the Vac, press the release
button in the hose assembly and pull the
hose out of the Vac inlet, as shown.
Power Head
Assembly
Drum
Latch
Drum
Press
and
Pull
Release
Button