brondell Swash Ecoseat 101 El Manual Del Propietario página 8

PRODUCT INSTALLATION (cont.)
CONNECTING COLD WATER SUPPLY (CONT.)
2 . Turn off Water Supply Valve and flush toilet
a . Turn Water Valve off to stop the flow of water .
b . Flush toilet and hold down handle to completely
empty tank .
c . Disconnect Water Supply Hose from toilet tank .
Do not disconnect from the Water Supply Valve .
NOTES:
• You may wish to place a container under the tank to
catch any excess water .
• Do not continue without completing the above steps .
• Failure to do so could result in flooding, leaking or
damage to the Swash .
3 . Connect T-valve to the Toilet Tank Fill Valve
a . Place the Rubber Washer into the T-valve .
b . Install the T-valve with the rubber washer to the incoming
water connection on the bottom of your toilet tank .
NOTES:
• The T-valve connects to the fill valve directly under
your toilet tank - it does not connect at the wall .
• Only connect to the toilet cold water supply line .
• If your water supply line is rigid, you may need to
replace it before continuing .
4 . Connect the water supply line coming from the wall to the
bottom of the T-valve .
6 6
Step 2c
Step 3a
toilet tank
t-valve
cold water
supply line
Steps 3-4