Programming For Dbs System - Jasco RM24940 Manual De Instrucciones

Programming For DBS Satellite Sys.
Most GE, RCA and ProScan Satellite systems
will not require programming. Check to see
if your DBS Satellite system responds to the
remote before you begin programming.
1. Manually turn on the DBS system. Find
the three digit code for your DBS
system at the back of the instructions.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release
the CBL/SAT button
(The INDICATOR
LIGHT will blink then
remain lit.
4. Enter the code
using the Number
Buttons. After your
code is entered, the
INDICATOR LIGHT
will turn off. If the code
is not valid, the INDI­
CATOR LIGHT will
blink. Check the code
list and repeat process.
5. Aim the remote at
your DBS system and
press the ON•OFF but­
ton. Your DBS system
should turn off.
6. With your DBS System on, press
CHAN+ (CHANNEL UP). If the satellite
system responds, no further programming is
required.
NOTE: If your DBS system does not
respond, try all the codes for your brand. If
the codes do not work, or your brand is not
listed, try the Code Search method on Page
12.
7. Enter your code
here for easy
reference.
CODE
SEARCH
CBL/SAT
1 2
4
7
CBL/SAT CODE
SATELLITE CODE
9
INDICATOR
LIGHT
SAT
(BLINK)
3
5
6
(OFF)
8 9
0
ON•OFF
CHAN +