En Original Instructions; Declaration Of Conformity; Specified Use; General Safety Instructions - Metabo PowerMaxx KP Manual Original

Original instructions
English

1. Declaration of Conformity

We, being solely responsible, hereby declare that
these cordless caulking guns conform to the stand-
ards and directives specified on page 3.

2. Specified Use

The device is designed to extrude sealant or adhe-
sive from cartridges or plastic bags.
It is not designed for foodstuffs or for medical/veter-
inary purposes. It should not be used with pressur-
ized cartridges. The caulking gun should also not be
used as a lifting/spreading tool.
The user bears sole responsibility for any damage
caused by improper use.
Generally accepted accident prevention regula-
tions and the enclosed safety information must be
observed.

3. General Safety Instructions

For your own protection and for the
protection of your electrical tool, pay
attention to all parts of the text that are
marked with this symbol!
WARNING – Reading the operating instruc-
tions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety warn-
ings and instructions may result in electric shock,
fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your electrical tool only together with these
documents.

4. Special Safety Instructions

Slightly acidic, flammable fluid may leak from
defective li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately with plenty
of water. If battery fluid leaks out and comes into
contact with your eyes, wash them with clean water
and seek medical attention immediately.
Protect battery packs from water and mois-
ture!
Do not use faulty or deformed battery packs!
Do not expose battery packs to naked flame!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.
Do not use frozen or set adhesive or sealant.
Do not overload the motor! If the motor is over-
loaded, switch off the device and remove the
battery pack. Determine the cause of the problem
and resolve it.
Refer to the instructions for assembling the device.
Ensure that the front cap, tube and threaded ring
are correctly fitted and securely fastened.
Always wear protective goggles.
Danger of crushing! Do not take hold of the toothed
rod (5)! Ensure that nothing is caught by the toothed
rod.
Follow national requirements for the materials you
want to work with.
Refer to the glue or adhesive manufacturers'
instructions and alsothe safety data sheet for the
consumable material.
Adhesives and sealants can be dangerous. For this
reason, you should always carefully read any
instructions on the container or other information
provided by the manufacturer about the material to
be used. Do not use materials without knowing what
risks they entail.
Do not use any solvent, acidic or other abrasive
cleaning agents.
Store the device and its components in a safe place
(e. g. ensure that the dismantled tube (3) is not
allowed to roll away).
5. Overview
See page 2.
1 Front cap
2 Nozzle (for plastic bag) *
3 Tube
4 Threaded ring for fastening the tube
5 Toothed rod
6 Rod knob
7 Trigger switch for switching the device on and
off
8 Adjusting wheel for setting feed rate
9 Battery pack release button
10 Battery pack
11 Plastic bag *
12 Screw
13 Extruder plate for plastic bags
14 Extrusion plate for cartridges
15 Cartridge *
* not included in scope of delivery
ENGLISH en
7