General Safety Warnings - Sonic 4800703 Manual Del Usuario

ENG

| GENERAL SAFETY WARNINGS

WARNING!
Study, understand and follow all instructions in this manual before operating the bottle jack. Failure to heed
these warnings may result in loss of load, damage to the jack and/or jack failure resulting in personal injury
or property damage.
Save all warning and instructions for future reference.
1. Read, understand and follow the warnings
listed in this manual.
2. Wear eye protection while operating this jack.
3. Inspect the jack before each use. Do not use
this jack if it is damaged or altered in any way
or if it is in poor condition.
4. Set up and use the jack on a hard, level sur-
face to prevent tipping.
5. The load must not exceed the rated lifting
capacity of the jack. Lift only dead weight.
6. Center the load on the jack saddle. Off center
loads can cause damage to the seals and can
cause hydraulic failure.
7. Use the jack for lifting purposes only. This jack
is designed to lift loads and not support them.
Support a lifted load with jack stands.
8. Use only approved hydraulic fluids.
9. Always place the bottle jack on a dry, oil/
grease free, solid, level floor surface capable
of supporting the weight of the jack and all
other additional tools and accessories.
10. Apply the vehicle's parking brake and chock
the tires before lifting the vehicle.
11. Lift the vehicle only by the manufacturer's
recommended lifting points.
12. Stay out from under the load while it is being
lifted or supported.
13. Avoid rapid load descent. Turn the release
screw slowly.
14. Do not use for aircraft purposes.
15. Do not leave the tool unattended.
16. Release the tool's load & lower the object
before leaving the area.
17. This product is not a toy. Keep it out of reach
of children.
18. When lifting only one wheel, make sure to
support the load immediately with one jack
stand placed under the side of the vehicle
being lifted.
19. Align the saddle of the jack stand directly
under the vehicle's seam or recommended
lifting point.
20. When lifting the entire front end or rear end
of a vehicle, make sure to support the load
immediately with two jack stands. Align the
saddles of the jack stands directly under the
vehicle's frame or recommended lifting points.
Also, make sure the jack stands are adjusted
at the same height.
21. Use the bottle jack only on vehicles whose
frames have lifting points (on its seam or
frame) capable of aligning with the bottle jack.
22. Do not use the bottle jack with the vehicle's
engine running. When running, the vehicle's
engine produces carbon monoxide, a colorless,
odorless, toxic fume that, when inhaled, can
cause serious personal injury or death.
23. Always keep hands, fingers and feet away
from all moving parts of the bottle jack when
applying or releasing a load. Remain clear of
the vehicle being raised or lowered. People
and animals should be kept at a safe distance
when using the bottle jack.
24. Do not allow anyone in the vehicle when using
the bottle jack. Keep all bystanders a safe
distance away from the vehicle.
25. Never use bottle jacks to lift both ends of a
vehicle at the same time.
26. Before lowering the bottle jack, make sure
tool trays, jack stands, and all other tools
and equipment are removed from under the
vehicle.
27. Before operating, insert the notched end of
the handle into the release valve. Turn the
handle clockwise until the release valve is
closed. Do not over tighten the valve.
28. Insert the operating handle into the socket.
Raise and lower the handle to raise the jack.
29. Lower the ram by slowly turning the release
valve counterclockwise.
S O N I C - E Q U I P M E N T . C O M
|