Connecting The Power - 3M PL300 Guía Rápida De Inicio

2. Connecting the power

The 3M™ Portable Labeler PL300 can operate using the rechargable battery pack
or the AC power adapter. For temporary backup power, six AA alkaline batteries
can be used.
To charge the battery pack the first time you
use the printer, insert the battery pack and plug
in the power adapter. Charging the battery
pack the first time takes approximately eight
hours. Recharging the battery pack will take
approximately two hours.
To insert the battery pack
Remove the battery compartment cover.
1.
See Figure 2.
Insert the battery pack into the battery
2.
compartment.
Replace the battery compartment cover.
3.
To connect the power adapter
Plug the power adapter into the power
1.
connector on the bottom of the printer.
See Figure 3.
Plug the other end of the power adapter
2.
into a power outlet.
2
Figure 2
Figure 3