The Rear Panel - Master audio DSP206 Manual Usuario

Master Audio
<Select:
Select>:
Menu:
Exit:
E) LCD - Shows all the necessary information to control the unit.
F) Copy/Paste keys – Currently no function assigned. For future implementation.
G) Rotary Thumb Wheel – Turn the wheel to change parameter data values. Click
on it to confirm the value entered. The center click of the wheel is also use to
browse different parameters of the same feature.
H) Output signal LEDs - Show the current level of the output Signal: Signal (-
48dBu), -6dBu, Limit (orange), Clip (red). The Limit led lights up if a gain reduction
is taking place (due to a programmed compressor). The Clip LED indicates a gain
this reduction is higher than 12dB.

3.2 The rear panel

DSP206
C
A B
DSP608
A) Power switch - Controls power On/Off.
B) Main Fuse – T315mA-250V. Slow blow type.
C) Main Power - Connects via a standard IEC socket. A compatible power cord is
supplied with the unit. The input voltage range is 200 to 240VAC, 50-60Hz.
D) XLR input and outputs - Separate 3-pin XLR connectors are provided for each
audio input and output. The device's output stage employs the balanced
impedance topology. All I/O connectors have pin 1 as ground (shield), pin 2 as +
and pin 3 as -.
DSP206-608. Version 1.2
Select previous parameter for editing
Select next parameter for editing
This key has different functions depending on when it is used:
In the Main Screen: Access the System Menu.
In the Main Menu allows entering the System Menu.
Exit to the Main Menu
D E F
Apr 14
D
6