Installation Requirements; Installation Hardware; Required Tools - Kenmore 580.73082 Manual Del Propietário

INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (559mm to 915mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 15 inches (381mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
Sash
115"min'.'innel sil[Lj_ Window
_° _' Sill
Interiorw_.J _."' FIG, I
_ Exterior
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on rightside of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the best way to store
unit during winter or when not in use.
INSTALLATION HARDWARE
ITEM NAME OF PARTS Q'TY
A SIDE CURTAIN 2
B SILL SUPPORT 2
C BOLT 2
D LOCK NUT 2
E SCREW: 25/64" 13
F SCREW: 5/8" 3
G SCREW: 5/8" 5
H FOAM SEAL 1
I FOAM STRIP 1
J _ L BRACKET 1
K DRAIN PIPE 1
REQUIRED TOOLS:
To avoidrisk of personalinjury,property damage,
or product damage due to the weightof this
device and sharpedges that may be exposed:
• Air conditioners coveredin this manualposean
excessiveweighthazard.Two or more people
are neededto move and installthe unit.
To preventinjuryor strain,use properliftingand
carryingtechniques when movingunit.
• Carefullyinspectlocationwhere air conditioner
willbe installed.Be sure it willsupportthe
weightof the unitover an extendedperiorof
time.
• Handle air conditioner withcare. Wear
protectivegloveswheneverliftingor carrying the
unit. AVOID the sharpmetal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end wrench or adjustable wrench
• 1/4-inch hex socket and ratcher
• Tape measure
• Electric drill
! • 1/4-inch drill bit
-5-