Publicidad
Idiomas disponibles
Idiomas disponibles
1.50 [38.1]
6.00 [152.4]
5.50 [139.7]
Area to be trim.
Metal clips "U" Nuts
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2008, 2018 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Ford Econoline
Figure 4.
3.00 [76.2]
3.00 [76.2]
Note:CONSULT VEHICLE OWNER BEFORE TRIMMING.
3.00 [76.2]
Figure 5.
Splash guard
Trimming recommended.
4.
Trim lower fascia as shown in Figure 4.
a. Locate the center of the fascia from left to right and mark
1-1/2" each side. ( 3" square)
b. Then mark 3" down from existing opening to create a
square cut-out
c. Drill (2) 3/8" hole in corners.
d. Carefully cut the 3" hole from the fascia.
.
Metal clips "U" Nuts
Trimming typical both sides of splash guard.
Sheet 2 of 6
65053N
Part Numbers:
65053
Area to be trim.
Forward
3-12-18
Rev. C
Publicidad
